Turbo gasket/rubber seal

I was fixing an issue on my friends 2.0d x type, the engine had lumpy power delivery and a

P0100 mass or volume air flow "a" circuit fault was detected on my code reader

Looking at the MAF sensor someone had bodged the connector in the past, i soldered it together correctly and used some JB weld to hold the wires in much tighter than before, the electrical issue was fixed.

However it appears the intake pipe that the MAF sensor attaches to was loose, the mounts holding it were worn and i fixed this by wrapping tape around the worn mount and it holds the part more solidly.

I noticed that where the intake pipe goes into the turbo the rubber seal or gasket was perished, is there a name for this part so i can order a new replacement?