All Activity

Hello guys, hope all of you are well. I've just picked up a new (to me) 2012 Jaguar XF X250 Luxury Sportbrake this week. Im liking it so far, however it has a few issues which I would like to ask for assistance/guidance from fellow owners and members. Issues : 1) Radio/audio button is greyed out, there is no sound at all 2) Satnav does not work, just stays on black screen and says initialising 3) Reverse camera does not load either, just stays on black screen. Parking sensors do work though, just not the camera. I have scanned using an Autel AP200, and have attached the report for the fault codes for you guys to take a look at and offer any suggestions. Also, the car has covered 135000 miles, and has never had a Cambelt change. When should I look into doing this? Thanks for taking the time to read my post, I look forward to your responses. PDF document.pdf

2003 Jaguar S type 2.5 V6 Jaguar Racing Green 106,000 miles full service history from one owner…..in lovely condition on surface. PROBLEM…… rusted plates underneath which has led to MOT failure. Sadly, I have had to give up driving. Therefore I will not be looking to repair. So offering for spare or repair at £600 Wrexham North Wales

Are your headlamps LED or HID? If neither you could probably get away with non-adaptive (as a general rule of thumb) but i would anticipate lots of error messages and potential MoT (or Spansih equivalent) failures.

Hi Alex I would expect you to be getting DTC codes if you are getting dashboard error messages It is possible you need Jag specific software. Have you checked the Fuel Pump Driver Module? Also I would re-check the need to recode a new fuel pump as Gemini (AI search) suggests it is needed. This might also help if you have not already found it. http://www.jagrepair.com/images/Electrical/XFWorkshopManual/Fuel System.pdf Good luck John

Thank you all for your help and advice! I have managed to get into the boot via the ‘secret’ keyhole!

Hi First post on here. Have a 2008 model lhd xk 150 convertible with adaptive headlights. The lights are uk spec and in their infinite wisdom the Spanish have decided ( after 5 years) that they are no longer acceptable. Can I replace with non adaptive versions as they are much easier to source or will I be bombarded with error messages. Thanks

Hi John, I've already cleaned the socket and main plug, removed small black plugs and hard wired them as recommended by Jag's technical bulletin JTB00301NAS1 from March 2014 (attached). The issue is not just that the fuel gauge reads low, its that the dash shows "Fuel pump system error" as well and has done with two different fuel pumps. I did look into the coding but according to JLR it's not a part that requires coding to the ecu or bcm. I've spent all evening looking at wiring schematics and I think I've gone a little cross eyed trying to figure this out JTB00301NAS1 - Fuel Gauge Operation.pdf

Hi Nanak https://www.vehiclerevolution.com/products/jaguar-xf-xfr-xfrs-rear-diffuser-black-abs-plastic-2008-2015 or think you need both of the below..... https://rimmerbros.com/Item--i-C2Z16212--SelectedCurrency-1 https://rimmerbros.com/Item--i-C2Z16211 Regards John

Hi Alex Have you looked for any stored error codes since the original problem? Only other thing that I can think of is that the replacement pump needs to be paired or coded to the car. Maybe this will help with the fuel gauge issue: Regards John

I've changed the fuel filter

Fuel filter?

Hi All, I'm at my wits end with this issue, I've had an odd issue in that when the car was on idle for a while or in very slow moving traffic I'd lose power almost completely and barely be able to pull away. After getting up to speed (eventually) the problem would go away, I thought it might be the pump in the tank as that died and the engine stopped but there were no errors on the dash or codes to read. I found there were a couple of corroded connections on the plug which I cleaned and repaired and that got the pump running again but it didn't seem to be moving fuel so I replaced the pump and managed to get the engine started and running again but now I get a fuel pump system fault on the dash. I've checked the pump, applied the fix from the official jag bulletin about the small black plugs failing and still getting the error although the car starts and runs. I've metered the sensors in the tank and they seem to be reading correctly as far as I can tell. I can hear the pump running to prime and when the engine is running but I still get the error and the fuel gauge showing empty. I'm concerned the in tank pump will cut out again as it has done once since it was replaced leaving us standing on the side of the motorway in the rain waiting for the RAC. My next guess would be a broken or frayed wire somewhere but from what I can tell the cable disappears through the rear bulkhead into the boot. I thought I'd ask for some advice before I start dismantling the car completely looking for a broken wire. an help would be greatly apreciated Alex

Have a look here; https://www.autodoc.co.uk/car-parts/interior-rear-view-mirror-13104/jaguar/xk/xk-8-convertible-qdv

Hi, I am now the proud owner of a 1998 (yes, that's right) beautiful XKR 4.0 convertible but the rear view mirror is so degraded it is useless. There are lots of 2nd hand rear view mirrors on Ebay for later models, but none for 1996-1998 models. My question is, does the specific year matter or are these mirrors reasonably interchangeable?

Had a similar problem on a peugot 206cc turned out there was a bearing sitting on top of the strut that had cracked after the previous owner hit a pothole. Think from memory there is a rubber damper on the top of the strut on the jags also

Not sure I’ll give him a call 👍

Have you had the shock absorber top mount checked not sure if there is a bush or a bearing

Hi everyone, further to my previous post I have now had new drop links fitted and anti roll bar rubber bushes, the knocking noise has certainly reduced to the point I thought it was cured, however driving today I can still hear it although greatly reduced. The jag mechanic says he has checked all joints and everything is good, but there is obviously something even my granddaughter asked me what the noise was, I’m now wondering if it could be worn brake calliper pins, has anyone any further thoughts. Many thanks

I have just been and collected a multimeter up from tool station. I tested the fuse box where the washer pump fuse goes and sure enough its reading a flat 0 when I press the button on the stalk for the washers. Just as a control I also tested where the fuse goes for the wiper motor which worked perfectly showing 14 something odd volt.

Thanks mate, yes it could be possible that is the case, im replacing the washer pump today when the new one arrives, so before I do il pick up a voltage tester and test at multiple points. Aswell as tracking down the earth, thankfully its only the windscreen washer pumps affected and nothing more.

Hi Thomas, I am a believer in the fault likely arises from the last action you took - you removed the washer pump and put it back into place - therefore by my thinking you have likely disturbed some element of the power supply wiring, most likely the earth. But perhaps that's just me being optimistic. Don't spiral to conclusions until you can get a meter onto the pump terminals to confirm you have the correct voltages where they should be. N6 JMX

It’s a long shot but does anyone have the XF RS rear bumper defuser that they are willing to sell? Iv priced one up from my local JLR dealer and I’m not paying £2000 for one and the ones on ali express look like the standard XF S defusers in either primer or carbon fibre finish.

Brilliant thank you.

Hi John Code is probably 1313 Sometimes 0000 or 1111 may work. Good luck John

Hello all, i noticed yesterday that my xf had a leak from the windscreen wash bottle, at this point the washer pumps for the headlights and windscreens were still working. I pulled the arch liner back to access the pump, I could see that it was leaking from the rubber grommet/filter on the pump. I removed the pump from the bottle but kept it plugged in to its power supply, I managed to seal it back up and stop the leak temporarily until the new one arrives. However upon driving my xf today I have noticed neither the washer pump for the windscreens or the pump for the headlights to be working, I have checked the fuse under the bonnet (f6 30a fuse) and its still intact. I dont dare disconnect the battery to check the bcm in the drivers footwell, im hoping its something simple, am I in denial that the bcm has infact been corrupted?