All Activity

Hi Scott, great catch, well done N6 JMX

Me again, Is my gear knob supposed to be lit-up at night when the car lights are turned on ? Only I can hardly see the design anymore (showing the gear positions) as the numbers are quite worn, although it doesn't bother me personally my wife says it's annoying as she doesn't drive it much so can never remember (as they are different to her car). Many Thanks, Les

Hi everyone, The rear parking sensors on my 2009 X-Type no longer beep when reversing close to something. (The front ones work if I click the switch located above the rear-view mirror). Have watched a couple of Youtube videos but non the wiser. Any ideas ? Could it be a dirty connector or something ? Many Thanks, Les

So after a few phone calls this morning i've got a JLR mechanic fixing the car next friday.He knew exactly what was wrong with it when i told him the code and told me it's a very common fault on the 2.0d Igneium engine and that it could have been worse if i hadn't caught the problem now.£600 including vat and thats parts supplied too which i thought wasn't bad...Pentland JLR wanted £178+ vat just for the part alone.I'll updated this thread when the work has been done.

History

Ancient

That’s great….. I will get that looked!! Thank you

Reluctantly selling this beauty as we have no space for it. The body work is beautiful, the wheels are in great condition. It’s runs well, and looks good under the bonnet. Interior is also good for its age. It’s only done 82,000 miles. It’s original with good history and a years MOT.

Turns out it has issues that is beyond my local garage...they've told me it'll need to go to a JLR specialist.

Could be egr valve, Just got this off internet hope it helps friend's XF had very similar problems...pulling away from junctions or roundabouts and the engine lost power briefly, before springing back to life. The Jag dealership had the car in several times but were unable to find the problem initially, it wasn't untill they had the car in for a few weeks that eventually the cause was discovered. They replaced the EGR valve (Exhaust Gas Recirculation Valve) and everything was fine thereafter. I hope this gives you something to look into. Or it could be fuel related

Thanks ... excellent. Found exactly what I require.

My XF 2.2 diesel 2013 I am having intermittent power loss when pulling away. The loss of power least for about 3 seconds then back to normal. It can be once in a journey or not at all. It’s had full service and new fuel filter. It’s been plugged in to a diagnostic and nothing shown. Does anyone have any suggestions? Or experienced this too? Any help is very much appreciated!!!

Hi. Apologies, I should have probably explained. I've recently had my engine rebuilt which included a new block being installed. I've trying to understand if I need to notify DVLA and get V5 changed. The company that did the rebuild work for me don't seem to engage with me now I've paid them and I'm struggling to get inormation from them.

Hi Stephen, one port of call can be the Jaguar Classic Parts website where you will find lots of data, including drawings and part numbers. The link below should take you to your bumper fittings. Xk8 Coupe/convertible 1997 - 2006 (x100) Classic / Bumper-rear-non Energy Absorbing | Jaguar Land Rover Classic Parts N6 JMX

Hi Jason, the engine number should be shown on your V5 document. Additionally, it is likely to be shown on a sticker on the B pillar. N6 JMX

Hi mate how bad is the body work damage

Hello everyone I've owned S-Type Jaguar since 2002. For the last 10 years I've had an 2004 S-Type. This morning while pulling out of my driveway they had repaved it and I skidded in gravel. Loss of traction. It didn't seem like a big deal however now it says restricted performance and as you know it's like Limp Mode. My regular mechanic doesn't work on this particular car and it's hard to find someone to work on an S-Type older than a 2006 here in St Louis Missouri United states. Although my car only has 125,000 miles on it. It's now acting different because of the restrictions. My mechanic suggested I disconnect the battery for a few hours. But it didn't work. This is my baby and I am on a fixed income as a disabled senior. Any ideas? [email protected]

Hi. I'm trying to find the location of the engine number 2016 XE 2.0d. Does anyone know wher to look for this? TIA.

"OLD"

Hi Jim..i checked all fluids on sunday morning like i do every sunday and everything was fine.I've put the car into my local garage tonight and they seem to think it's a sensor too but won't know until tomorrow when they get it onto a code reader.I've got my fingers and toes crossed thats all it is but my luck is terrible so i'm expecting the worst but hoping for the best.

Can anyone enlighten me as to the fixings holding on the back bumper? Mine is secured by cable ties, apparently placed after the car had some welding done on the wheel arches. Is there a diagram of the necessary parts available anywhere. Thanks in advance.

Car won't start (2014, 130k miles) it was throwing up some EGR related error codes (P245a). It's had a new EGR valve fitted, but no joy. Took it to a specialist who didn't do much investigation, said there was no fuel getting to the injectors and will need a new high pressure fuel pump. Has anyone experienced anything similar? Or have any clue what might be the issue. Cheers

Years

Hello There, I am a new and proud owner of a 2002 S-TYPE R . To maintain it I purchased an IDS SDD kit from tools4car. It is running from windows XP laptop. I can read almost all of the ECUs except the ECM and the rear sensors ECU. To be able to solve the ECM reading I have to go the configuration menu then select configure existing module then select Engine management then when asked for file K16_s42pm.bin I cancel the process (I didn't try to downlod this file). Only after all that the communication with ECM is back. Does anyone have an idea of what is going on ?

Have they sorted out the dpfand timing chain issues yet what year or chassis number did they sort it out from