Jump to content


Recommended Posts

Posted

I would appreciate if anyone has knowledge of, or photos of the correct fitting kit for a 2005 (facelift) S Type. Have checked on internet but there are various photos/diagrams/etc., showing what is supposedly the correct kit. However the vast differences that have shown up are just serving to make me wonder if suppliers do actually know what is needed.

My own feelings are that the only fittings needed are a D Clamp (for joining the Cat Con pipe to the remainder of the exhaust) and an "O" Ring type mesh/gauze gasket that will squash between the manifold and the Cat Pipe, (when it is clamped on with the two stud/nut flange).

I am wanting to have everything to hand before the job of fitting a new Cat is started and can then be completed, all in one process with correct parts.

Many thanks in anticipation of your informative responses and help.

Regards and Best Wishes , John.


Posted
On 11/7/2021 at 4:44 PM, Wrinkly said:

I would appreciate if anyone has knowledge of, or photos of the correct fitting kit for a 2005 (facelift) S Type. Have checked on internet but there are various photos/diagrams/etc., showing what is supposedly the correct kit. However the vast differences that have shown up are just serving to make me wonder if suppliers do actually know what is needed.

My own feelings are that the only fittings needed are a D Clamp (for joining the Cat Con pipe to the remainder of the exhaust) and an "O" Ring type mesh/gauze gasket that will squash between the manifold and the Cat Pipe, (when it is clamped on with the two stud/nut flange).

I am wanting to have everything to hand before the job of fitting a new Cat is started and can then be completed, all in one process with correct parts.

Many thanks in anticipation of your informative responses and help.

Regards and Best Wishes , John.

Purchased, as specified for my car:

 

DSCF4423.JPG

  • 3 months later...
Posted

Where can I buy an OEM spec Catalytic converter for my 2005, 2.5, S-type at an affordable cost? I need to have mine replaced urgently as an MOT is due next week and the RHS (driver side) catalytic is completely melted in the middle section. I would highly appreciate any leads. Thanks.

A little background if this might help someone else diagnosing their car's issues.  The car was purchased from a previous owner who probably desperately tried solving the issues with makeshift repairs. Bank 1 had a misfire on cylinder 1,3,5. There was a vacuum leak and Oil leaking at the lower IMTV solenoid due to original worn out o-rings and excessive use of gasket maker. I also found a doggy repair on the RHS (bank 1) cam sensor connector (which is my guess to the misfires on a complete bank). The OBD shows the car has been driven in Restricted Performance Mode and the check engine light has been on and flashing intermittently for over 40K miles, the total being 118000 miles as off now. 

After sorting out the cam sensor connector the car only goes into restricted performance and the check engine light only comes on at low RPM's. I switched O2 sensors from Left to Right and vice versa and still had the same issues. I finally managed to get a borescope and check both ends Upstream which has an intact honey comb structure and downstream which has alien like formations on RHS catalytic converter. 

Posted
3 hours ago, wolfpeace87 said:

Where can I buy an OEM spec Catalytic converter for my 2005, 2.5, S-type at an affordable cost? I need to have mine replaced urgently as an MOT is due next week and the RHS (driver side) catalytic is completely melted in the middle section. I would highly appreciate any leads. Thanks.

A little background if this might help someone else diagnosing their car's issues.  The car was purchased from a previous owner who probably desperately tried solving the issues with makeshift repairs. Bank 1 had a misfire on cylinder 1,3,5. There was a vacuum leak and oil leaking at the lower IMTV solenoid due to original worn out o-rings and excessive use of gasket maker. I also found a doggy repair on the RHS (bank 1) cam sensor connector (which is my guess to the misfires on a complete bank). The OBD shows the car has been driven in Restricted Performance Mode and the check engine light has been on and flashing intermittently for over 40K miles, the total being 118000 miles as off now. 

After sorting out the cam sensor connector the car only goes into restricted performance and the check engine light only comes on at low RPM's. I switched O2 sensors from Left to Right and vice versa and still had the same issues. I finally managed to get a borescope and check both ends Upstream which has an intact honey comb structure and downstream which has alien like formations on RHS catalytic converter. 

Bought mine a few months ago from here, along with the Catalytic Converter Seemed . OK they know there stuff, were very helpful and delivery was quick. Product is of good quality. Photos of product on my earlier submission regards Catalytic converter.

https://www.onlineautomotive.co.uk/cheap-car-parts/Proton/Catalytic-Converters?gclid=EAIaIQobChMInLjE2b2C9gIVCO3tCh0H9AjVEAAYASAAEgLGTPD_BwE

Best Wishes and Regards, John

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...





×
×
  • Create New...



Forums


News


Membership


  • Insurance
  • Support